john lucas

Chain Ornaments-1-2

I was stuck in Walmart while my wonderful wife was shopping so I hung out in the craft area (DUH it's either there or the outdoor section) Anyway I had layed out a piece of ceiling fan chain to make an ornament with a chain finial. I saw the necklace chains and the crosses and I had to have them. It's really hard to get the chain down a hole just big enough to fit so here's a tip. Hold the chain so about an inch hangs down. Then drip some medium CA on the last 1/2". spray it with accelerator. Now you have a stiff portion that's easy to get down the hole. Put some more CA on this section and then slide it in the hole and let it sit. The one on the right end is an experiment and you will probably see more of those soon. Most of these ornaments are solid but I hollowed the Walnut one on the left end.

Chain Ornaments-1-2
  • There are no comments to display.
  • Album:
    square ornaments
    Uploaded By:
    john lucas
    Date:
    Oct 17, 2017
    View Count:
    214
    Comment Count:
    2

    EXIF Data

    File Size:
    78.6 KB
    Mime Type:
    image/jpeg
    Width:
    600px
    Height:
    382px
    Aperture:
    f/16.0
    Make:
    NIKON CORPORATION
    Model:
    NIKON D5100
    Date / Time:
    2017:10:17 06:47:45
    Exposure Time:
    1/100 sec
    ISO Speed Rating:
    ISO 1600
    Focal Length:
    70 mm
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).