georgetroy

Gluing on Vicmarc 300

I use the funnels on the Oneway Revolving Centers. On large segmented glueup it's the Curt Theobald centering funnel.

Gluing on Vicmarc 300
georgetroy, Jan 8, 2006
    • Natastic Emerson
      Want to trade lathes?
      I have a Jet 1236 with a non-functioning tailstock and a busted Reeves drive.
      It goes two speeds: one's a whiny squeal the other's too fast for bowls.
    • Ed Koenig
      I like you have a VL 300 but I would not use it as a clamp for glue ups. Unnecessary pressure on the bearings will only cause them to fail faster. Consider a segmented screw press. Check out this web site for some great ideas. http://www.turnedwood.com/index.shtml
    There are no comments to display.
  • Category:
    Member Galleries
    Uploaded By:
    georgetroy
    Date:
    Jan 8, 2006
    View Count:
    5,190
    Comment Count:
    2

    EXIF Data

    File Size:
    56.7 KB
    Mime Type:
    image/jpeg
    Width:
    700px
    Height:
    525px
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).