Rusty Fleeman

Mesquite Hollow Form

Mesquite Hollow Form
Rusty Fleeman, Jan 20, 2017
    • Bill Boehme
      Nice work, Rusty. I see that the borers collaborated with you on this piece.

      It looks like there was a void or a bark inclusion . I suspect that made it a challenge to turn. How large is the piece?
    • odie
      Sanding the interior of that one must have been a bear! :eek:

      ko
    • Rusty Fleeman
      @Bill Boehme it's 6" at its widest point and 10" tall. The longhorn borers did the hard part for sure!
    • Rusty Fleeman
      @odie sanding was easier than you think. I have a drum the same diameter as the hole. Add that to a drill extension and a drill, then run through the grits. It did try to hang once, but the tolerances are just too close to be a problem. I did have to keep my fingers crossed a time or two & utilize some stretch wrap while turning!
      odie likes this.
    There are no comments to display.
  • Category:
    Member Galleries
    Uploaded By:
    Rusty Fleeman
    Date:
    Jan 20, 2017
    View Count:
    463
    Comment Count:
    4

    EXIF Data

    File Size:
    1.5 MB
    Mime Type:
    image/jpeg
    Width:
    3264px
    Height:
    1836px
    Aperture:
    f/2.2
    Make:
    samsung
    Model:
    SM-G900H
    Date / Time:
    2017:01:18 21:34:24
    Exposure Time:
    1/30 sec
    ISO Speed Rating:
    ISO 320
    Focal Length:
    4.8 mm
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).