Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
Congratulations to Keven Jesequel for "Big Leaf Maple" being selected as Turning of the Week for April 15, 2024
(click here for details)
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Yes. I call them 30 minute hollow forms. I turn the OD and tenons on each end between centers, knife off the base with a 1/16 Sorby parting tool. Chuck, drill and bore out the cylinder. Then comes the critical part: sizing the base to fit so there will be no obvious seam. Things have to be square and fitted immediately. Once any distortion sets in it gets hard to get a mating joint.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.