1. Join the Go-To Source for Woodturners!

    Please read the new sticky announcement here for full details.

    Dismiss Notice
Stacey S

ULU Cutting board

this is a cutting board that I have made for my brother for Christmas. It is designed to use with an ULU(That is the curved knive in the picture) It is about 9.5" square and 1.25" thick. Chucked on the lathe with a recess and the bowl turned until just larger than the knife. The woods are oak, Padauk, and maple. finished with Mahoney's walnut oil

ULU Cutting board
Stacey S, Dec 23, 2005
    • Redfish
      Did you make the ULU? Is this a kit you can buy?

      I used to be a meat cutter and I love specialized cutting equipment. My fav knife is my 14" "machete".
    • GuyO
      Ditto on the request about the knife -- I've found the blade but cannot locate the 7/32 rivets ( or the instructions for pounding a brass rod into a rivet).
    • Stacey S
      I purchased the knife from a place in Alaska. The are on the internet. I think the name of the place was "The ULU factory"
    There are no comments to display.
  • Category:
    Member Galleries
    Uploaded By:
    Stacey S
    Dec 23, 2005
    View Count:
    Comment Count:

    EXIF Data

    File Size:
    63.6 KB
    Mime Type:

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).