I need to remove carnuba wax from a bowl. I tried sanding but the sanding disc clog up from the wax. Any ideas on how to get it off?
-
We just finished moving the forums to a new hosting server. It looks like everything is functioning correctly but if you find a problem please report it in the Forum Technical Support Forum (click here) or email us at forum_moderator AT aawforum.org. Thanks! -
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Dave Roberts for "2 Hats" being selected as Turning of the Week for April 22, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Removing wax from bowl
- Thread starter Raymond Sprouse
- Start date
- Joined
- May 16, 2005
- Messages
- 3,540
- Likes
- 15
Gouge. Sanding clogs, and, if you press, liquefies it to flow in further. Imagine the difficulty will come in mounting the piece for the job. I'm sort of lucky, because I use mortises on the bottom of mine, and if it doesn't sell with the finish/thickness it has, I re-turn it.
Either that, or a lot of agony with solvent soaks and rinses prior to your next sanding.
Either that, or a lot of agony with solvent soaks and rinses prior to your next sanding.
john lucas
AAW Forum Expert
Mineral spirits will take it right off. At least it did on the one I needed to remove wax from. You might need a tooth brush if you have any crevices or larger pores.
Steve Worcester
Admin Emeritus
Abranet.
Sand it off, get's built up, hit a crepe pad to clean it, and repeat.
Solvents will take the bulk off, but also flow it into the pores. OK, hit it with solvents first to get the top layer off.
PM me an address and I will send you a sample. Specify 2" or 3" and I can hook you up.
Sand it off, get's built up, hit a crepe pad to clean it, and repeat.
Solvents will take the bulk off, but also flow it into the pores. OK, hit it with solvents first to get the top layer off.
PM me an address and I will send you a sample. Specify 2" or 3" and I can hook you up.