Anybody with any experience fixing the digital readout on my Lathe. Lathe works fine, one day readout works the next morning it doesn't. It still seems to be putting out the signal when I check inside the belt compartment. The sensor is shining on the wheel.
-
We just finished moving the forums to a new hosting server. It looks like everything is functioning correctly but if you find a problem please report it in the Forum Technical Support Forum (click here) or email us at forum_moderator AT aawforum.org. Thanks! -
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Peter Jacobson for "Red Winged Burl Bowl" being selected as Turning of the Week for April 29, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Powermatic 2014 digital readout problem
- Thread starter Gerry Patton
- Start date
My friend replaced his last week.Powermatic sent him a new digital readout.Lousy Chinese electronics.
Thanks, I'll give them another call. They didn't call be back yesterday. Was it hard to replace? Looks difficult to access.
It could also be the hall sensor that may not be set close enough to the metal that it is reading. If you go onto the internet you should be able to find a manual that would show the mounting of the sensor.