The Oliver has 6" grinding wheels, My Delta wolverine has 8" does the angles change?
Thank you
Ed
Thank you
Ed
-
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Keven Jesequel for "Big Leaf Maple" being selected as Turning of the Week for April 15, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Oliver tool chisel grinder
- Thread starter Ed Jarvis
- Start date
john lucas
AAW Forum Expert
Depends on where the V arm and the rest of the jig is located. I went from 6" to 8" things changed a little probably due to the accuracy of how I mounted the hardware. The actual bevel of the tool changes very little. Same thing happens when you replace a worn wheel with a new wheel.
The Oliver does not use a V arm it uses a bar that the angle is adjustable across the wheels. I will set the angle properly with my Wixley angle Gauge. Any suggestions?
- Joined
- Apr 27, 2004
- Messages
- 8,629
- Likes
- 4,970
- Location
- Lakeland, Florida
- Website
- www.hockenberywoodturning.com
The big difference is the increased concavity of the bevel on smaller wheels. A micro bevel and or honing corrects for the concave bevel.
The concave bevel is a tiny bit harder to control since the cut wants to follow the bevel. A tool with a concave bevel wants to cut deeper all by itself. I hand sharpen my spindle tools so they have a flat or convex bevel.
Bowl gouges I use straight from the grinder.
The angles are not dependent on wheel size -bevel angles depend on the supporting geometry of the mechanisms - platforms, vee pockets etc.