• Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Paul May for "Checkerboard (ver 3.0)" being selected as Turning of the Week for March 25, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

FS: Barracuda Micro Lathe Chuck, Jaws $50 + shipping

Status
Not open for further replies.

Mark Hepburn

Artist & Chef
Joined
Mar 26, 2014
Messages
1,621
Likes
577
Location
Houma, Louisiana
EDIT: I've cleaned and shined it up and added a couple more photos.

This is a small, Barracuda Micro key operated scroll chuck I've had and used for a while. I have three of the Barracuda 2 chucks that I like and use a lot for smaller work but will be replacing as I move up to the Vicmarc 120s over time.

So, I do like this chuck but am going a different direction and so am hoping to sell this and another chuck. It's mechanically sound with zero issues, but does have some blemishes.

It is complete as purchased (minus the blow-molded case, which I threw away a while back). It includes the chuck, key, hex wrench, 3 sets of jaws, extra screws and the screw chuck.

Here are the specs on the jaws:
Included Jaws: Pin,#1,#3
Pin Jaw Grip: Internal: 7/8" to 1-5/8"
#1 Step jaw gripping: External: 1/16 to 13/16"
Internal : 5/8 to 1-3/4"
#2 Standard Jaw gripping: External: 3/32" to 1-3/8"
Internal: 11/16" to 2-3/8"


Bought for $130. Asking $55.

I'll ship however you like. The chuck weighs about a pound and the rest of the items probably another pound.







IMG_5440.JPG IMG_5441.JPG IMG_5442.JPG


IMG_5423.JPG IMG_5424.JPG
 
Last edited:
Joined
Mar 12, 2016
Messages
74
Likes
33
Location
DFW, TX, USA
Does that have 1"-8tpi threads? Also, is that rust on the chrome pieces, or some kind of residue?

I'm on the fence because it's similar to the one I have already, but it would be nice to have a spare with different sized jaws installed...
 

Mark Hepburn

Artist & Chef
Joined
Mar 26, 2014
Messages
1,621
Likes
577
Location
Houma, Louisiana
Barry,

It's 1" x 8 tpi threads. the color is some transtint orange.
 

Mark Hepburn

Artist & Chef
Joined
Mar 26, 2014
Messages
1,621
Likes
577
Location
Houma, Louisiana
Does that have 1"-8tpi threads? Also, is that rust on the chrome pieces, or some kind of residue?

I'm on the fence because it's similar to the one I have already, but it would be nice to have a spare with different sized jaws installed...

Barry, I'll clean it up some more before I send it out. I just didn't think of it to tell the truth. I'm like you: I have a few of the other chucks so I have the jaws already installed. If only I could do that with the Vicmarcs!
 
Status
Not open for further replies.
Back
Top