• We just finished moving the forums to a new hosting server. It looks like everything is functioning correctly but if you find a problem please report it in the Forum Technical Support Forum (click here) or email us at forum_moderator AT aawforum.org. Thanks!
  • Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Dave Roberts for "2 Hats" being selected as Turning of the Week for April 22, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

FS, Vicmarc 18" Adjusta-Jaw set

Status
Not open for further replies.
S

Steve Tiedman

Joined
Oct 25, 2020
Messages
233
Likes
195
Location
Minneapolis, MN
For Sale, 18" Vicmarc Adjusta-Jaw set for the Vicmarc VM120 and VM150 chucks. Used only a few times, but I sold my 24" lathe, no use for them anymore. Essentially in brand new condition. Includes the 4 plates, red rubber grippers and the gripper screws. See the photo- the full closed diameter is just over 19" diameter, your lathe needs to have a greater-than 20" swing to effectively operate the chuck with these plates attached. Final fitment to the lathe is the buyer's responsibility.

Sold new at Craft Supplies for $140, I'm selling these, including cont. USA USPS shipping, for $75. (Shipping to Alaska, Hawaii, or Canada may be higher and buyer will cover that cost.) Payment by Venmo (a service of Paypal) or personal check (shipped after check clears my bank) would be accepted. Will arrange for a local purchase, too (Minneapolis, MN).

Thanks,
Steve.
20201122_115006.jpg 20201122_114906.jpg
 
S

Steve Tiedman

Joined
Oct 25, 2020
Messages
233
Likes
195
Location
Minneapolis, MN
The Vicmarc jaws have been sold, thanks John.

This thread can be closed.

Steve.
 
Status
Not open for further replies.
Back
Top