Congratulations to Curt Fuller for "Bell Ornaments" being selected as Turning of the Week for October 27, 2025
(click here for details)
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
I have two swan-necked tools. One is a Dennis Stewart tool (now sold by Sorby I think), the second I bought at a club auction and is home made. Both of these are not very different from Bosch or Jordan tools. But the farthest reach I can get on these "flying saucer" shapes with a small-ish opening is the Jamieson bar.
Many times I will turn once to a thin wall while green, and let the piece warp. But this one was twice turned: turned it soon after harvesting, air dried it in a paper bag, and then put it back on the lathe. Nothing special for drying.
I have two swan-necked tools. One is a Dennis Stewart tool (now sold by Sorby I think), the second I bought at a club auction and is home made. Both of these are not very different from Bosch or Jordan tools. But the farthest reach I can get on these "flying saucer" shapes with a small-ish opening is the Jamieson bar.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.