This little guy is inspired from the latest FUNdamentals article on making inside out snowmen written by John Lucas here on the Forum. I started with a 7/8" board and cut it into three 4.5" sections each section cut to 60 degrees. I glued each section together with CA glue turned the inside profile as some coves that reduced in size. Then I split it and reglued with Titebond and turned the outside profile to resemble a snowman! Finished with wax, the size is 3.5" tall and 1.75" in diameter. This was really fun process and I enjoyed adding the bell on the inside and the red beanie on top.
