Serial 22004

I'm amazed you were able to cut clean threads in both of those, even with the CA to firm them up.

Steven Forrest said:

I'm amazed you were able to cut clean threads in both of those, even with the CA to firm them up.

Click to expand...

It was a long drawn out process that probably was not worth the effort but I did it just to see if I could.
The first step on the female thread was to soak the bore with thin CA.
The second step was to cut a partial thread and reapply CA.
The third step advance the cutter about 5 to 10 thousands inch the reapply CA.
The fourth step etc. repeat step 3 until the thread was complete.
Next repeat the process on the male thread.