• Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Keven Jesequel for "Big Leaf Maple" being selected as Turning of the Week for April 15, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

robust

  1. K

    American Beauty or Powermatic 4224B

    Good day everyone! There have been many posts regarding the Robust AB vs the Powermatic 3520 series but I haven’t seen much on the 4224. Can anyone share their thoughts comparing these two? Well loaded the 4224 comes in a little over 3k less than the AB. Thanks all!
  2. Christopher Parnell

    Oneway 2436, 2036 or Robust 24

    Looking for a used Oneway 2436, 2036 or Robust 24 short or preferably long. Thought I’d check in before going for a new. Thank you! With folded hands, Christopher Parnell
  3. Jim McLain

    Robust American Beauty Long Bed SOLD

    Selling my American Beauty Long Bed Lathe. Package includes: 3HP Baldor motor Swing away with gas shock assist Extra banjo Wheel/caster set not pictured Tool caddy Auxiliary power strip mounted to back of lathe M33 spindle but could be changed out by Robust to your preference Standard...
  4. Larry Steinmetz

    Larry Steinmetz

    Hello all, I typically don't lurk so long before joining a forum but have been checking out and enjoying this forum for several years now. As an introduction, I am a retired active duty Coast Guard/Navy Chief Warrant Officer (4 years Navy & 29 years CG) who is still employed by the Coast Guard...
  5. B

    WTB Powermatic or Robust

    My Jet 1440 is in need of an upgrade. I'm looking for a good condition PM 3520B/C or a Robust in the Pacific Northwest. Any leads would be appreciated. Thanks, Bill
Back
Top