• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • Congratulations to Chris Lawrence for "Dragon's Grip" being selected as Turning of the Week for March 30, 2026 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

1.5 hp oneway 2036 opinions?

I

Isaac Davis

Joined
Jun 18, 2021
Messages
80
Likes
24
Location
Portland, OR
I have the opportunity to pick up an older oneway 2036 with a 1.5 hp motor for a steal. I turn lots of big bowls and I want to be able to core on this lathe, will 1.5 hp be enough to core with? I don't have the hunter carbide cutter, but I do plan on picking up a couple and I fell like that must make a huge difference in the torque required.
 
You can stall nearly any motor on any lathe being aggressive enough. I have a 2hp 2436 so I don't have first hand experience with the 1.5. So the question you need to answer is; are you willing to core a little slower than if you had more hp, because 1.5hp will certainly core blanks. It's your decision to make. If it's a steal, buy it and try it. You don't like it, sell it for a profit. I would have already had the lathe in my shop if the steal is really a steal.
 
Richard Coers said:
You can stall nearly any motor on any lathe being aggressive enough. I have a 2hp 2436 so I don't have first hand experience with the 1.5. So the question you need to answer is; are you willing to core a little slower than if you had more hp, because 1.5hp will certainly core blanks. It's your decision to make. If it's a steal, buy it and try it. You don't like it, sell it for a profit. I would have already had the lathe in my shop if the steal is really a steal.
Click to expand...
cool, that's kinda what I figured. It's such a great deal and comes with so much stuff that I can't really pass it up.
 
Sounds like a no-lose proposition. On many lathes swapping in a bigger motor is pretty straightforward if you decide 1.5 isn't enough. I wouldn't think the difference between 1.5 and 2 would be particularly noticeable, going to a 3-5 hp motor probably would. (Note it's still pretty easy to stall a 3 hp motor when coring a big log)
 
A 1 hp motor can core, but it is difficult. Most of the difficulty is if the blade is binding in the cut. With the Oneway, if your pivot point for the blade is dead center in the ways, then almost no problems. If you are off to either side, then you will have to do 1 1/2 to 2 full kerf widths to be able to core all the way down to the center. 1 1/2 hp should be sufficient. I have cored on a 1 1/2 hp Jet lathe that ran on 120 volt and had stalling problems. Coring on the Jet with the 1 1/2 hp motor on 220 volt, pretty much no problems.

robo hippy
 
You must log in or register to reply here.
Back
Top