3520B VFD Help Needed

[George Sherwood]

Good afternoon, I'm working to replace my VFD and I'm absolutely horrible when it comes to electrical. I followed Johns instructions but admittedly that VFD he used is not longer available as far as I can tell. I picked up the newer version which is the K100-2R2G1. I have it on the lathe and wired. I did remove the wire from the potentiometer and wired as John did on his. The issue is the programing is not the same anymore. The values don't match up from his post. The new one starts with 00.00 - 16.04. I've tried to match up the settings from the original Delta Inverter I found online and I have something wrong. Is anyone willing to look at the settings for this inverter and tell me what they should be?

Thank you in advance for any help!

 

[George Sherwood]

I had to scan the programming pages from the manual, its not online anywhere I can find.

 

[George Sherwood]

Trying to add all the programming pages.

 

[George Sherwood]

Last one. Please ignore the numbers I wrote in because they obviously are incorrect. The motor will run from the VFD if I hit run but nothing on the front panel works.

 

[Larry Komroff]

Hi George, I know that programming can be frustrating. I found a link that might help YouTube Video .

 

[George Sherwood]

Hi George, I know that programming can be frustrating. I found a link that might help YouTube Video .

Thank you!

 

[Larry Komroff]

George, check your direct messages (envelope icon to the right of your name near the search)