• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • February 2026 Turning Challenge: Cookie Jar! (click here for details)
  • Congratulations to Matt Carvalho for "Red Mallee Folded Form" being selected as Turning of the Week for February 9, 2026 (click here for details)
  • AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

A different epoxy question

olaf Vogel

olaf Vogel

Joined
Mar 10, 2015
Messages
347
Likes
150
Location
Aurora, Ont, CA
Website
www.revolvingarts.ca
My wife is a painter, who has been sealing her work, with a coat of epoxy.
Art Resin (https://www.artresin.com/) has been her choice because

- many other artists are using it here
- its VOC free, so can be used indoors - critical during (eternal....) Canadian winters
- its easily available
- it resists yellowing under UV

I started using on bowls and found it quite good as well. The first coat gets thinned down by about 50% alcohol, to aide penetration and a more dramatic grain. The second coat is not thinned.

Additionally, this sands well.

Last week, i used it the first time to create a River Table, using a black walnut, edge edge plank. It worked, but...

The material is quite soft and scratches easily, on the table, her artwork and my bowls.
My sailboat is also epoxy (gel coat) and thats quite hard.

Upon contacting Art Resin, they maintain that our ambient temperature should have been above 23C, which our basement likely was not. We'll try again.

I did pour in 1/4" layers, as recommended, but it definitely looks like layers. It my first such attempt, maybe more practice.

So when looking an alternative epoxy solution, what should I look for?

A - harder / more scratch resistant.
B - Low or VOC free. For example, this one gets into a lot of detail, but what is really safe?
https://docs.wixstatic.com/ugd/243cac_8b826220401843a1b95d84f742f8f9e4.pdf

Thanks for the help
 
They market Art Resin as an epoxy clear coat. Not as a casting resin. They don't list any chemicals on the safety sheet. I'm guessing that it may be a catalyzed acrylic finish, and will not perform like a solvent based epoxy or casting resin. That could be the reason you see the layers, there isn't any chemical burn-in. I would also ask them about some strength numbers if you intend to use it for a river table. If it's that soft, it may also have little strength.
 
I used a casting resin in a project years ago to simulate a puddle of water. It is softer than the West System Epoxy I use most of the time. It scratches very easily. It is not cold here in Tennessee and was cast in my heated shop so I know temperature is not the reason.
 
You must log in or register to reply here.
Back
Top