Using the standard T-handle wrench with Cole Jaws installed is pretty time consuming because the handle does not reach beyond the jaws. Is there a solution for this?
-
February 2026 Turning Challenge: Cookie Jar! (click here for details) -
Congratulations to Dean Center for "After Life" being selected as Turning of the Week for February 16, 2026 (click here for details) -
AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
-
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Extended T-Handle Wrench for Nova Cole Jaws?
- Thread starter Tom Albrecht
- Start date
What model chuck is it, SuperNova 2 or G3?
Bill previously started a thread with a similar question:
I put my suggestion in there:
I solved the problem by knocking out the handle rod. Then I epoxied the end into a 9/16 socket. I used a 9/16 because it was the size that fit well and I had plenty of extra ones sitting in the drawer. Has worked great for years. Epoxy is more than secure enough to handle the relative little force used on my Cole jaws. Socket extension gives me enough length to use a ratchet to tighten.
Jay
Jay
I put my suggestion in there:
In that case, Jays suggestion might be your best bet.
john lucas
AAW Forum Expert
I have a Vicmarc chuck. It uses a standard metric Allen head wrench. So I took a spare Allen key and cut off an inch and welded it to a rod that I put in a handle. Also I can use a ball end Allen in place of my welded one.
Last edited:
For anyone lucky enough to have something like the SuperNova 2 that uses a Hex key, these are all viable solutions with either plain or ball end.
I knew with the potential for loss or wear of a chuck key, buying the Supernova or Titan models (that just take a hex wrench) would be a smarter move for me than getting chucks with a unique fitting key. I haven't lost any yet, and I didn't think about ownership of multiple chucks providing me with multiple keys...