- This is a stock picture; this is the model I am selling. I will post pictures later today of my actual lathe. I wanted to get up quickly in time for holiday gifting! The lathe is in very good condition. Asking price is 1,800.00 Pick up is in Culver City CA. Very easy access from the driveway. Please let me know if you have any questions.
- There is a standing platform included if you like to raise you up 6" for optimal ergonomic positioning for the shorties like me
- There are accessories included, tool rests, extra drive belt etc. I just have to sort them out from what I am keeping so I can list and post a pic.
GENERAL DIMENSIONS
■ Spindle Height: 44½”
■ Power Input: 220V, Single Phase
■ Length x Width: 47 x 23½”
■ Bench Height: 30”
■ Weight: Approximately 300 lbs.
12½” swing over the bed (9” swing over Banjo) 24” between centers
11” Stainless Steel Toolrest with 1” Post
2 step pulley (50 - 2000 / 100 - 4000 rpm)
Two position Control Box
Spindle is hardened and ground
Spindle Thread: 1” - 8tpi RH (inboard ¾” - 16tpi RH (outboard)
7/16” thru hole (in spindle)
24 position indexing
#2 Morse Taper in headstock & tailstock
Forward & Reverse with two pre-programmed accel / decel settings
1HP Motor
High Performance Powder Paint on Stand & Lathe Cast Iron Tailstock with Acme thread & 3” quill travel Patented clamping mechanism in Banjo
Offset Bed for easy clean up
Last edited: