Restoring a General 260 with a reeves drive Looking for a headstock pulley for it the part number is 263-V2 according to the manual.
Thanks!!!
Thanks!!!
-
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Keven Jesequel for "Big Leaf Maple" being selected as Turning of the Week for April 15, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Headstock pulley for General 260 Vs lathe
- Thread starter Chris Britton
- Start date
- Status
You are not even allowed to talk about an Asian made machine on that site I believe.
A General 260 is a Canadian made lathe. Before General International took over.
Thank you
That hurt lmao ... this one was made in late 70s and from Canada. Wouldn’t own a Asian machine
The last model of the 260 General made used a 3 phase motor, VFD, and a 4 step "V" pulley. If it was my lathe I would consider going that direction instead of restoring the reeves drive. 3 phase motors are cheap on the used market. Good ones can even be found in the junkyard. I also would use a poly rib flat belt instead of V belt for more efficient power transfer.
- Status