• It's time to cast your vote in the April 2025 Turning Challenge. (click here for details)
  • Congratulations to Steve Bonny for "A Book Holds What Time Lets Go" being selected as Turning of the Week for 28 April, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Hollowing Heads for the woodcut handle?

B

Bowen Turner

Joined
Jul 31, 2004
Messages
46
Likes
1
I have a woodcut bowl saver and I would like to get a hollower. Is there a hollowing tip that would fit the woodcut handle? Trying to save some $$$

Thanks all,
 
Last edited:
Woodcut handle

Your Woodcut Bowlsaver handle has a 1/2 inch bore. Thus any tool with a 1/2 inch shank should work. Woodcut offers an unguarded cup cutter with a 1/2 inch shank that works well in this handle. Being unguarded, particularly for someone with little experience hollowing, it is better suited for goblets and other open forms where you can keep an eye on the cutter while gaining experience determining the best orientation of the tool. You can also fit 12mm tang tools like the Vermec hollowers. The fit is just a little loose, but easily acommodated by the set screw.

Your handle is a little short for deeper hollowing, but one thing that I have found improves its function is to make up a wooden or plastic plug for the tool end, then fill the back of the handle with lead bird shot (available from most gun shops). The added weight and damping will likely be most appreciated, and should you not like it, is easily removed.
 
You must log in or register to reply here.
Back
Top