• Congratulations to Phil Hamel winner of the April 2025 Turning Challenge (click here for details)
  • Congratulations to Steve Bonny for "A Book Holds What Time Lets Go" being selected as Turning of the Week for 28 April, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Jet air filtration AFS400

Peter D'Attomo

Peter D'Attomo

Joined
Jan 19, 2009
Messages
288
Likes
137
Location
Surprise, Arizona
Thought my remote went bad, but it's not. Put unit back together and a red(Pink) wire slipped out of the 8 position connector from motor to PC board. The PC board only has 4 connections, so I reinstalled it on that slot. Now the unit won't go on, but if I disconnect power and reconnect, the unit goes on for 30 seconds on high, 5 seconds on medium and the shuts off. Talked to 2 Jet techs but do not have advice except " it's a PC board problem" Before I fork over 45 bucks, I'd like more info. Any ideas?
Thanks
Peter
 
Peter, I had a similar problem with my Jet AFS-1000B. I found a bad capacitor on the board, I replaced it with a 2200uF 10V Radial Electrolytic Motherboard Capacitor, now it runs perfectly. If this is your problem I would gladly send you a capacitor, I have three extra.
 
You must log in or register to reply here.
Back
Top