I've purchased one from a local supplier -- the chuck was pressed togther from two pieces, the inner threaded component and the chrome outer component. The inner threaded component was mis-drilled and was off center by about 3/8". Three others in this store had the same problem.
I happened to be a town about 150 miles north of the original purchase location, stopped into a store from the same franchised chain - they had 4 of them all with the exact same error.
This is the $79 chuck that was recently on sale for $72.00 -- was the whole boat load from China bad?
Has anyone gotten a good MT2 colllet chuck that wasn't an Axismaster or a Beall?
I happened to be a town about 150 miles north of the original purchase location, stopped into a store from the same franchised chain - they had 4 of them all with the exact same error.
This is the $79 chuck that was recently on sale for $72.00 -- was the whole boat load from China bad?
Has anyone gotten a good MT2 colllet chuck that wasn't an Axismaster or a Beall?