• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • Congratulations to Bernie Hyrtzak, People's Choice in the January 2026 Turning Challenge (click here for details)
  • Congratulations to David Croxton for "Geri's Basket Illusion" being selected as Turning of the Week for February 2, 2026 (click here for details)
  • AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Termite Tool

Dave Fritz

Dave Fritz

Joined
Jul 24, 2008
Messages
764
Likes
222
Location
Montfort, Wisconsin
When using my Termite tool I have to push really hard to get it to cut. I've watched the video and seem to be sharpening it correctly and using it properly.

Does anyone have experience with this tool and if so can you give me some tips?

Thanks,

Dave F.
 
I use termite tools frequently and like them a lot. I'm assuming you're using the tool to hollow out a bowl or hollow form, either end grain or side grain. I use it for both. Here's how I set mine up and use it. The tool rest is set slightly above center (1/4"-3/8") and the tool bit is presented to the wood vertically so it touches the wood at center or slightly below (1/8"-1/4"). At this point the tool will not cut or cuts very little. I slowly rotate the tool bit to the right until it starts cutting. It shouldn't take much rotation to get it to cut. Be very cautious about how far you rotate the tool bit. The more you rotate the bit, the more aggressive the cut. As the tool starts to cut, the handle of the tool is slowly moved to the right, staying at the same angle. You are basically pulling the tool into the wood and you should be getting long shavings, especially in green wood. I made a very long handle for my termite tool so I can put the butt of the tool in my armpit to help control the cut. Hope this helps.
Tim Carter
 
Think of the tool as a gouge mounted at 90 degrees to the handle and follow regular gouge protocols. It's more difficult to get the high entry angles with the termite, which is why Craterdog recommends a combination of rotating and opening the circle while pulling the handle away from parallel to the sides. Just be careful you don't over-rotate, or you can hook big time.

I you have a long handle with your tool you may wish to use it as the turners of old used the hook tool. You just can't run a shaving out the open portion, so you don't want to be quite as aggressive as you could be lest you jam shavings in the ring.

Note that you have two different bevel angles. As always, lesser included peels better.

http://www.youtube.com/watch?v=Vk7I31-D4No Nice video. Others on the right side.
 
You must log in or register to reply here.
Back
Top