What chuck do these jaws fit?

[Scott Morgan]

I have a set of 2" jaws that I'm wondering what chuck they fit. The hole pattern is the same as a Nova G3, oneway tommy bar chuck and the oneway talon but the raised portion on the bottom of the jaws does not match the groove in the chuck. However the raised portion does match the groove on the oneway stronghold chuck, but the screw hole pattern doesn't match. Hope someone can shed some light on this matter.

Thanks kindly,
Scott

 

[Neil S]

They look like the Vicmarc shark jaws on the inside, but unlike the Vicmarc they don't also have the shark jaw teeth on the outside. Perhaps they are 3rd party jaws made to fit on a Vicmac chuck. There are a few of those out there.

To check to see if they would fit on a Vicmarc VM90/100, see my recent post...

Name those jaws!

Can you please help me out (again)? What are these chuck jaws? I was given two pairs of jaws (with a load of other stuff, including some chucks). But I can't work out what these jaws are meant to fit! They don't seem to fit a VersaChuck (with any of the kinds of jaw carrier), an RP SC4 or a...

www.aawforum.org

The centre of the screw holes on the Nova and Vicmarc VM90/100 jaws are the same distance apart, but the Nova use 6mm screws and the Vicmarc 5mm. And, just to be confusing, the larger Vicmarc VM120/140/150 chuck jaws also use a 6mm screw, but those little jaws aren't going to fit on any of the larger Vicmarc chucks.

 

[Lars Hansen]

Some early original Vicmarc Shark Jaws had a straight outside.
I recently saw two sizes in their original boxes.