Mark Hepburn
Artist & Chef
UPDATE: SOLD. PLEASE CLOSE THREAD. THANKS!
Selling my Woodcut coring tool. I've used it a couple of times at most and it's been collecting dust for some time now. Full disclosure: It seems awfully hard for me to move the cutter across the poly "bumper" at the leading edge (shown in red). I think it's just that I haven't set the cutter properly.
It's a simple system for those who've not used it before. Mount it on the toolrest post, plug it into the tailstock, adjust and then swing the handle around to come into contact with the blank.
This tool has two cutters, both of which are installed on the cutter as shown. I've linked a copy of the manual for anyone who would like to give it a look: https://www.woodturnerscatalog.com/docs/woodcut_bowlsaver.pdf
I'm asking $200 + the cost of shipping. It weighs about 12 lbs.
If you want to contact me, please PM (conversation), or you can text me at 985 860 1106
Or email me: hepburnmarke @ gmail.com
Thanks,
Martk
Selling my Woodcut coring tool. I've used it a couple of times at most and it's been collecting dust for some time now. Full disclosure: It seems awfully hard for me to move the cutter across the poly "bumper" at the leading edge (shown in red). I think it's just that I haven't set the cutter properly.
It's a simple system for those who've not used it before. Mount it on the toolrest post, plug it into the tailstock, adjust and then swing the handle around to come into contact with the blank.
This tool has two cutters, both of which are installed on the cutter as shown. I've linked a copy of the manual for anyone who would like to give it a look: https://www.woodturnerscatalog.com/docs/woodcut_bowlsaver.pdf
I'm asking $200 + the cost of shipping. It weighs about 12 lbs.
If you want to contact me, please PM (conversation), or you can text me at 985 860 1106
Or email me: hepburnmarke @ gmail.com
Thanks,
Martk
Last edited: