• May 2025 Turning Challenge: Long Neck Hollowform! (click here for details)
  • Congratulations to Phil Hamel winner of the April 2025 Turning Challenge (click here for details)
  • Congratulations to Dion Wisniewski for "Basketweave" being selected as Turning of the Week for 12 May, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Woodcut Pro-Tip

R

Raif Harik

Joined
Jan 14, 2020
Messages
282
Likes
101
Location
Austin, TX
Hi, has/does anyone use the woodcut Pro-Tip system? Essentially it's a long solid bar and a short bowl gouge section that you screw onto the bar. This gives the tool extra rigidity if you are turning aways off the tool rest. I saw Ronald Kanne using one for a bottom feeder and it looked like a good system. But I'm wondering if anyone has experience with it, especially in the states. My questions being: how long is the usable tip? And where can you get them in the states? I've seen a couple retailers who sell the initial setup but I haven't seen the tips anywhere so I don't know what that might cost.
Thanks,
Raif
 
You must log in or register to reply here.
Back
Top