I have been searching for almost an hour thru the forum archives... Cant find a good definite answer. Just cut about 7 Koa blanks. Turned 4 already. Loaded with alive termites... Even inside, when you stop you can see them, I use a few picks to dig them out... These are going to be Polo thropies. So I have to leave a wide rim so they can engrave names etc. I will not hollow it out too much, will make a nice round curve. I'm thinking they will all fit in a big trash can, then I can throw a smoke poison bomb , a fogger. Have to check if the fogger kills termites. Lots of the termites are in the larvae stage, but they are breathing, right? Lol. Any other ideas are greatly appreciated. I kept spraying regular bug killer, what I use for the house and shop, kills roaches etc, the larvae and winged termites that came into contact are dead, but, that does not penetrate the little caves. I will only fill the holes on the rim, as the laser engraver needs a smooth surface, I hope the laser will cut the same thru wood and resin... I will leave all other holes open, and I hope I can kill all termites, I can see a player calling telling me bugs are coming out of the trophy!! Thanks in advance for the help!! Aloha