Even though Bonnie taught us how to cut grooves in the end of spindle stock and tap the spur drive into the wood, I never do this on my lathe. I have one of those 4-spur drives with a spring-loaded point. I make small center marks with an awl on each end, hold one up to the drive center with the point seated, slide up the tailstock into the right position, and then use the hand wheel to tighten (not too tight). Usually will take a couple passes with the roughing gouge, tighten again, repeat. After 2 or 3 times, no need to tighten any more. Any reason (or certain circumstances) I should change my ways?