I have a question for all you turners that Laminate and create Segmented turning blanks.
What glue is the best?? The reason I ask is that I make a few goblets that are made with a glued up center core with larger pieces glued onto the core.
After several months after the turning and finishing is done, you can feel the glue migrating out of the joint. Is this bad glue or bad technique?? The wood was dry cherry and dry hard maple. The glue I used was milk based LePage wood glue outdoor. It says it's water resistant that's why I used it for goblets.
Any clues???
What glue is the best?? The reason I ask is that I make a few goblets that are made with a glued up center core with larger pieces glued onto the core.
After several months after the turning and finishing is done, you can feel the glue migrating out of the joint. Is this bad glue or bad technique?? The wood was dry cherry and dry hard maple. The glue I used was milk based LePage wood glue outdoor. It says it's water resistant that's why I used it for goblets.
Any clues???