I have been using the brass threaded inserts with the last few urns I made. I used to make an insert and then chase threads. This added a lot of time, and I have run out of big pieces of boxwood. I like to make my opening at least 2.5 inches wide. I'm using the 3-inch brass insert. Rick Brantley recommends 5 minute epoxy for the inserts. The recent post about using an eyedropper type of applicator with CA made my light bulb go off. What if I can suck up the mixed epoxy into a syringe to then apply it where it goes. Right now i'm using little popsicle sticks and some skewers. I tape the area around the spigot to prevent staining. I know a syringe would be a one time use. Price is not a problem, I'm getting good money for my urns. The question is if the epoxy is too thick. Has anybody tried this? Or do you have any tips to apply epoxy more efficiently? Thanks in advance, stay safe, Aloha