Hello everyone!! I’m currently very new to wood turning, I bought a wood lathe about a week ago. I’m innately very ambitious, with that characteristic I was ‘all in’. But I hit a slight problem I didn’t have a chuck nor a live center, nor did i have any proper tools. I STILL have those same problems. Haha. I know I dont necessarily need a chuck or live center. But the problem with that is I have a want to turn smaller pieces of wood. Do anyone have any suggestions, Ideas, options, advice!?… like I said I have little to next to nothing but a bare bones wood lathe. ..the obvious solution would be to purchase these components but I’m in a very difficult financial situation and have little to no funds at the moment. Yes, I’m employed, yes I work extremely hard 6-7 days a week , yes I do what ever it takes to make ends meet! ..again I would greatly appreciate with much gratitude if I could get some good advice, suggestions, options, ideas! Don’t be timid I have a open mind approach to almost everything I encountered! Thank you guys!