• Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Keven Jesequel for "Big Leaf Maple" being selected as Turning of the Week for April 15, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Artisan by Henry Taylor 1/2" bowl gouge (x3)

Status
Not open for further replies.
Jamie Straw

Jamie Straw

Joined
May 28, 2015
Messages
1,554
Likes
178
Location
Bainbridge Island, WA
Three each of these 1/2" HSS Artisan bowl gouges, made by Henry Taylor for Craft Supplies -- pardon shadows in photo. A good size for roughing out green bowls efficiently, wide and deep flute. They are unhandled and the bases were spun down by our Metal Arts staff so that they fit in D-Way 5/8" handles. Very little use, and all in green wood. When in stock at CS, they're $92 ea. (with handle of course). Asking $25 ea. for the top two in photo. $20 for the bottom one because it got dinged up when the handle was removed (just on the base of tool, not flute). Cost for shipping will be less than $10, Flat Rate USPS. I could get two in a package, but probably not 3. Grind is 55 degrees with pretty long wings, certainly can be changed.

I have the handles, but they cost too much to ship. Note: it'll be Monday before I can get any shipping done..

Artisan Gouges.jpg Artisan Gouges Mark.jpg
 
Last edited:
Status
Not open for further replies.
Back
Top