-
Congratulations to Bernie Hyrtzak, People's Choice in the January 2026 Turning Challenge (click here for details) -
Congratulations to David Croxton for "Geri's Basket Illusion" being selected as Turning of the Week for February 2, 2026 (click here for details) -
AAW Symposium demonstrators announced - If the 2026 AAW International Woodturning Symposium is not on your calendar, now is the time to register. And there are discounts available if you sign up early, by Feb. 28. Early Bird pricing gives you the best rate for our 40th Anniversary Symposium in Raleigh, North Carolina, June 4–7, 2026. (There are discounts for AAW chapter members too) For more information vist the discussion thread here or the AAW registration page
-
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Beal Buffing a Pen
- Thread starter jeffnreno
- Start date
Put them on the mandrel (with homemade wooden bushings) and buff away.
I assume you are talking about the turned pen parts and not just the brass tubes themselves. Don't buff the brass tubes. You'll mess up your wheels big time and you want a rough surface on the tubes before gluing, not polished.
Ed
I assume you are talking about the turned pen parts and not just the brass tubes themselves. Don't buff the brass tubes. You'll mess up your wheels big time and you want a rough surface on the tubes before gluing, not polished.
Ed
I always buff them while they are still on the mandrel. After removing them I apply a little finish to the bare ends of the barrels and this is touched against the buffer. You can't buff the pen once assembled, the finish will be taken right off the metal parts.
john lucas
AAW Forum Expert
Anytime your holding something small buff from the middle down then flip the pen and do the same. If you buff with the pen sideways it will easily pull it from your hands. I buff the finials on my ornaments which are very delicate. I try to hold the piece at about 45 degrees and never buff toward a pointy edge. Always make sure the wheel is running down and out on crisp edges and you won't have a problem.
Jeffnreno,
I find that I usually have my mandrels full when I'm ready to buff a pen. Holding the small pen barrels by hand I too would end up having the barrels fly out of my hand and sometimes get damaged. I've found that a piece of all thred with 2 nuts works great. I cut the all thred a couple of inches longer than needed slide on the pen barrels and run the nuts up until snug. This will leave an inch or so at each end to hold on to and spin around as needed. If needed I use the bushings for the larger sizes.
GA Darling
I find that I usually have my mandrels full when I'm ready to buff a pen. Holding the small pen barrels by hand I too would end up having the barrels fly out of my hand and sometimes get damaged. I've found that a piece of all thred with 2 nuts works great. I cut the all thred a couple of inches longer than needed slide on the pen barrels and run the nuts up until snug. This will leave an inch or so at each end to hold on to and spin around as needed. If needed I use the bushings for the larger sizes.
GA Darling
Last edited: