So, thanks everyone for your comments. I have been considering all of these choices, and it becomes clear why....they are all reasonable. Probably leaning towards a Laguna....but, still no decision. I am having torque issues with my Delta...basically, it’s hard to turn at low speeds because of stalling out....no, I’m not trying to take too much! Or, perhaps I am. As to the why not 220v question....it’s a matter of expense. I have been quoted $1500 To place a line. This is not my profession, and I have already spent a fair amount of cash getting started....lathe, tools, dust collector, grinder, personal protective gear, sharpening jig....wood....lt all adds up. Still haven’t purchased a pressure pot....lord knows I need one!!! At any rate, enjoying turning a few pieces a month for relaxation and expression....yes, would love 220. At present, not realistic. Thank you all, again.