What size bolt is used to hold the Oneway bowl steady to the clamp bracket? It appears to be 1/2 inch by 2 inches but I wanted to be sure. Thanks.
-
August 2025 Turning Challenge: Wooden Version of Non-Wood Item! (click here for details) -
Congratulations to David Croxton for "XOXOXO" being selected as Turning of the Week for August 11, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Bolt Size
- Thread starter Dave Fritz
- Start date
- Joined
- Aug 31, 2006
- Messages
- 339
- Likes
- 138
- Location
- Montgomery, TX
- Website
- www.gulfcoastwoodturners.org
Call Oneway and ask them. Most reliable source. - John
Friend measured theirs. Got it. 1/2 by 13 by 2
When you purchases a Oneway you get the whole company with it.
You'll be put on the phone with one of their engineers or with Kevin, president and owner.
While I would make that call, I will also bet that the bolt is metric. If it looks like a 1/2", it's probably a 12mm
You'll be put on the phone with one of their engineers or with Kevin, president and owner.
While I would make that call, I will also bet that the bolt is metric. If it looks like a 1/2", it's probably a 12mm
If you are talking about the bolt that holds the base to the lathe bed, it is 1/2" on mine.
1/2"-13 bolt, which means 1/2" outside diameter and 13 threads per inch.