• November 2025 Turning Challenge: Wall Hanging! (click here for details)
  • Congratulations to Craig Morton, People's Choice in the October 2025 Turning Challenge (click here for details)
  • Congratulations to Andy Chen for "Mesquite Vase with Polymer Clay Millefiori" being selected as Turning of the Week for November 3, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Bowl explosion

That’s when it happened to me. I’m glad the piece that went flying didn’t hit me since the piece had sharp edges! I’m sure it missed because I had my face guard on. :rolleyes:
 
Kennith Gosnell said:
Turning a pecan bowl and taking one last cut before removing. Put a small dent in my face shield. These are the only parts i have found so far.
Click to expand...

Did you determine if the wood was defective or was there some extra force, perhaps from a small catch?

I might glue together the piece found and display it as a reminder to wear the face shield!

JKJ
 
Smart guy with the face shield. I posted recently about the smashed lip/nose I received from an ash bowl. I don't feel like typing the details again, but I wasn't even making my last cut. I was literally done with sanding the bottom on the Longworth chuck, and took my face shield off for a close inspection just as I moved my right hand to turn it off (but inadvertently rolled my finger across the speed knob (and I had also forgotten to change the belt from high to low!), at which point disaster struck before I could react. I got very lucky with just a busted lip, some bleeding and swelling, and hurt pride, but I learned my lesson: lathe spinning equals face shield in place, even if I'm "done."That mistake could have easily resulted in an ER trip and reconstructive surgery.
 
Suggestiongestion
AI can be a useful source of information to turners
I asked the question what would happen if a bowl 10inch diameter 3 inch thick rpm 1000 came off the lathe
In addition to list of possible injury's and first aid measures the web site provided this information

Please note I am not attempting to promote a site but simply exposing members to a source of information which may be useful


What to do (recommendations)​


  1. Check balance & secure mounting — true the blank, use a good faceplate/spigot, and make sure it’s well centered before any high-speed work. Use tailstock support for roughing when possible.
  2. Use progressive speeds — start slower for roughing (to remove heavy cuts and reduce vibration), raise speed for lighter finishing cuts if desired. For a 10" bowl many turners commonly work in the ~600–1,200 rpm range depending on lathe, mounting, and comfort; 1,200 is toward the upper end for that diameter.
  3. Inspect the blank for checks, cracks, bark inclusions or voids — if present, reduce speed or don’t spin that fast.
  4. Sharp tools & light cuts at higher RPM — reduce cutting engagement; use lighter passes to avoid catches.
  5. Personal protective equipment & safe stance — always face shield, no loose clothing, and stand a bit to the side when starting the motor.
  6. Avoid sanding heavy stock at full speed — it heats the wood and the sandpaper; use moderate speeds for sanding or very light pressure.
  7. If you feel excessive vibration, noise, or looseness — slow down or stop immediately.
 
You must log in or register to reply here.
Back
Top