Are there special techniques for turning a bowl where the depth approaches the diameter or maybe even goes beyond?
My tool rest is somewhat limited in how far it can go inside the bowl and the gouge starts getting squirrely. I've had some success using a scraper in a deep bowl but that has its limitations too.
Any help is much appreciated.
Yes, I've joined the AAW and this fall I'll start attending the Ohio Valley Woodturners Guild meetings. They seem like nice folks, and I've always said that the best instruction manual is a mentor.
My tool rest is somewhat limited in how far it can go inside the bowl and the gouge starts getting squirrely. I've had some success using a scraper in a deep bowl but that has its limitations too.
Any help is much appreciated.
Yes, I've joined the AAW and this fall I'll start attending the Ohio Valley Woodturners Guild meetings. They seem like nice folks, and I've always said that the best instruction manual is a mentor.