odie
TOTW Team
- Joined
- Dec 22, 2006
- Messages
- 7,109
- Likes
- 9,708
I'm noticing fine grinding particles stick to a few of my HSS lathe tools while grinding, and assume a few of them may have become magnetized.
One of the machinists at work said to strike the shaft on a hard surface, but I'm not willing to do that, at this point.
There are electric demagnetizers that I know of, but wondering if there is any way to eliminate this without expense.......?
ooc
One of the machinists at work said to strike the shaft on a hard surface, but I'm not willing to do that, at this point.
There are electric demagnetizers that I know of, but wondering if there is any way to eliminate this without expense.......?
ooc