Mark Hepburn
Artist & Chef
I haven't really done any small turnings before, but want to do some lidded boxes. Probably 3" O.D. and a few inches deep.
So how do those of you who do these turnings sand the interior? Tried the index finger and let's say it's less than optimal.
Of course, if I were a really good turner then I probably wouldn't need to sand. But "start at 60 grit" is my motto !!
Anyway, advice most appreciated.
Thanks,
Mark
So how do those of you who do these turnings sand the interior? Tried the index finger and let's say it's less than optimal.
Of course, if I were a really good turner then I probably wouldn't need to sand. But "start at 60 grit" is my motto !!
Anyway, advice most appreciated.
Thanks,
Mark