How many people use a 4 inch extension in there tail stock to make more room getting away from the tail stock
And where did you get it from. Thanks
And where did you get it from. Thanks
Thanks will look thereI have several taper adapters.
one of them it’s aM2 to M2 adapter which essentially extends the taper.
it is probably about 4”. Aka Morse taper extender.
you will need a drift key to get the taper out of it.
I’ve used it more to extend the spur drive from the headstock when I wanted to drive a blank with a void in.
using this the spur can be close to 6” inside a hole and the blank won’t hit the headstock
hardly ever use it in the tailstock. I don’t even like to extend the ram too much
Does add length to a drill bit with a M2 taper.
lots of machinery places have them. Packard Woodworks or craft suppies should have them
Thanks for a morning laughThe screw driver to lever it out, the tape measure so you can tell us how far the ejected piece flew across the shop...