I got smacked dead center of the face shield today. Had it been just safety googles, I would have had to put my snooz back in place. Other than a few choice words that would have made a sailor blush, it was a non event.
-
May 2025 Turning Challenge: Long Neck Hollowform! (click here for details) -
Congratulations to Phil Hamel winner of the April 2025 Turning Challenge (click here for details) -
Congratulations to Paul Hedman and Donna Banfield for "Fire and Ice" being selected as Turning of the Week for 5 May, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Face shield works
- Thread starter Webb Willmott
- Start date
Good on you for wearing the safety equipment. I am at a point that I ALMOST never turn without it.
Safety is, first and foremost, a choice!! Good choice! 
I almost always use my face shield as well. I don't with the drill press, but everything else I do I use it. I used to not use it on the bandsaw, then something snapped while using that, and pieces of wood went flying. Honestly not real sure what happened, but ever since I face shield that too!
I almost always use my face shield as well. I don't with the drill press, but everything else I do I use it. I used to not use it on the bandsaw, then something snapped while using that, and pieces of wood went flying. Honestly not real sure what happened, but ever since I face shield that too!
Face shield also for those who use bench grinders with traditional wheels - can get invisible cracks, throw chunks and even break. (Worse if it has a wire wheel like I have in my little welding shop! Or using a wire wheel on an angle grinder. These can throw metal needles.)
But a bandsaw incident that throws wood is highly unusual. There are only two things I know of that can do this. One is sawing wood that wasn't totally supported all the way to the table, round, angled, unstable on the table. The other is wood with cracks, voids, punky areas, something that suddenly gave away during the cut causing an unsupported cut. Can be worse with an aggressive cut. Could that have been what happened? (Both failures can bend up or even break a blade too.)
As for other shop safety: for anyone unaware, with the drill press the face is not usually a target it can damage the hands and such if the bit catches when drilling something held by hand - can grab the work and instantly spin it. This is usually less problem with wood than when drilling steel. I have two clamps on my drill press and use them or along with a vise, depending on the size of the work, wood, plastic, or metal.
JKJ
Glad you're ok.
My bandsaw incident was probably because it was an odd piece of wood, it wasn't flat and square.
With the drill press, I always clamp things down, or have a fence in place, and try not to have my hands as the only thing holding stuff down. Or in a pen vise, etc. Occasionally I've not tightened a clamp down enough, and something will twist a bit when it shouldn't. Mostly, though, I think the drill press is the safest machine I have.