For Sale, 18" Vicmarc Adjusta-Jaw set for the Vicmarc VM120 and VM150 chucks. Used only a few times, but I sold my 24" lathe, no use for them anymore. Essentially in brand new condition. Includes the 4 plates, red rubber grippers and the gripper screws. See the photo- the full closed diameter is just over 19" diameter, your lathe needs to have a greater-than 20" swing to effectively operate the chuck with these plates attached. Final fitment to the lathe is the buyer's responsibility.
Sold new at Craft Supplies for $140, I'm selling these, including cont. USA USPS shipping, for $75. (Shipping to Alaska, Hawaii, or Canada may be higher and buyer will cover that cost.) Payment by Venmo (a service of Paypal) or personal check (shipped after check clears my bank) would be accepted. Will arrange for a local purchase, too (Minneapolis, MN).
Thanks,
Steve.
Sold new at Craft Supplies for $140, I'm selling these, including cont. USA USPS shipping, for $75. (Shipping to Alaska, Hawaii, or Canada may be higher and buyer will cover that cost.) Payment by Venmo (a service of Paypal) or personal check (shipped after check clears my bank) would be accepted. Will arrange for a local purchase, too (Minneapolis, MN).
Thanks,
Steve.