Insert

[Tom Gibbons]

I like the idea of the Ruth niles insert but I like the one that is open on both ends
The problem is it’s not stainless
Does anyone have an idea where to get a stainless insert that is open on both ends
That would be the same style

 

[hughie]

I would think with a little care and slow rpm's you could open the bottom end up quite well. Oh and some decent cutting compound I use Rocol, see here https://www.rocol.com/distributors

 

[Doug Freeman]

SS is difficult to find. If you must have SS, search for “rivet nut”. I have used them in wood with success (epoxy to hold them in). You may not like the design.

 

[stu senator]

Look at:

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

Stu

 

[Tom Gibbons]

Look at:

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

Stu

To expensive $5 each