Getting an E7 error code on machine for the second time in 1 year. Has anyone experienced this and is there a fix?
Thanks
Peter
Thanks
Peter
-
It's time to cast your vote in the May 2025 Turning Challenge. (click here for details) -
Congratulations to Maggie Shapiro for "My 2nd Basket Illusion" being selected as Turning of the Week for 26 May, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Jet 1221 error code
- Thread starter Peter D'Attomo
- Start date
Hi Rich, Appreciate your info. My question was more about is this a design flaw and has anyone found a solution. This is the second time within a year the error pops up. Replaced both parts last time.
Peter
Peter
Will the lathe run with the error code? If so just ignore the error code.
no, but if I spin the handwheel it will start
What if it is a design flaw, what would you do differently than just replace the bad part? Did you check the position of the speed sensor? I know some Powermatic lathes had trouble with the sensor coming loose.