Jet Mini Headstock shaft length?

[Tom Albrecht]

I have to do a demo tomorrow using a Jet Mini lathe (not mine). I am making a draw bar for a #2 MT Collet Chuck and I don't know how long to make it.
Can anybody help with an approximate shaft length measurement?

Thanks

 

[Bill Boehme]

@Tom Albrecht, 6¾" from the hole in the handwheel to the nose of the spindle.

I just noticed that you posted your question yesterday so this is too late to help.

 

[Tom Albrecht]

@Tom Albrecht, 6¾" from the hole in the handwheel to the nose of the spindle.

I just noticed that you posted your question yesterday so this is too late to help.

Hey Bill, thanks anyway. I just used a longer rod than needed and left some hanging out. I'll cut it down for next time.
Thanks again.