• The forum upgrades have been completed. These were moderate security fixes from our software vendor and it looks like everything is working well. If you see any problems please post in the Forum Technical Support forum or email us at forum_moderator (at) aawforum.org. Thank you
  • Congratulations to David Bartell, People's Choice in the March 2026 Turning Challenge (click here for details)
  • Congratulations to Chris Lawrence for "Dragon's Grip" being selected as Turning of the Week for March 30, 2026 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

McNaughton Center Saver Question

Samuel Russo

Samuel Russo

Joined
Oct 8, 2017
Messages
30
Likes
6
Location
Binghamton, NY
I just bought the McNaughton Standard size system. My question is, the blades are thicker at the front end and therefore do not slide between the pins. Consequentially, the Tool Post must be a distance from the work piece. Is this typical for this tool.
 
Yes it is because the kerf needs to be a lot wider than the blade. I did just a bit of work on the blades using the grinder to allow the gate to be a little closer to the work. I also tried to fair the wide leading edge into the blade a a little more smoothly. My blades were very rough on the top and bottom edges so I spent some time with a file laid flush to flatten those surfaces and then polish them so that they would slide more smoothly. It is also important to break the sharp edges at the top and bottom or else that will also create problems.

I deleted your attached file. I assume that you didn't mean to attach that file.
 
Bill Boehme said:
Yes it is because the kerf needs to be a lot wider than the blade. I did just a bit of work on the blades using the grinder to allow the gate to be a little closer to the work. I also tried to fair the wide leading edge into the blade a a little more smoothly. My blades were very rough on the top and bottom edges so I spent some time with a file laid flush to flatten those surfaces and then polish them so that they would slide more smoothly. It is also important to break the sharp edges at the top and bottom or else that will also create problems.

I deleted your attached file. I assume that you didn't mean to attach that file.
Click to expand...
Thanks.
 
I've got an older system with the old-style post/turret. Seems that i can get it up close to the face without a problem. Is this a problem with the Mark 2 version?
 
You must log in or register to reply here.
Back
Top