I was looking at Kalia's Kelton hollowing tool with the thin layer of some hard steel welded to another piece of steel.
The question I have is: If I took a piece of a nice 1/8" thick planner blade, and silver soldered that to a piece of O-1 drill rod.....would the heat from the soldering change the hardness of the planner blade steel?
I have made some very nice 1/8" scrapers out of planner blades. Even some thicker planner blades too. But, have never heated them as hot as soldering would take them.
Thanks ahead of time. Another project.......
The question I have is: If I took a piece of a nice 1/8" thick planner blade, and silver soldered that to a piece of O-1 drill rod.....would the heat from the soldering change the hardness of the planner blade steel?
I have made some very nice 1/8" scrapers out of planner blades. Even some thicker planner blades too. But, have never heated them as hot as soldering would take them.
Thanks ahead of time. Another project.......