I would like to inset gorgeous Burl pieces in turned bowls. I have numerous Burl slices about 3/16 thick by 8 inch by 20 inch. High end Burl veneers. I would like to dye and then inset into Outside of turned bowls. Any help on how I would go about this with router setup or something else, on or off the lathe. I’m thinking a jig on lathe to carve the square or other shape in which these pieces can be glued in. I have vacuum set up for veneering . Has anyone out there did this and give me some advice on how to do it. Here is a rather crude drawing. I have almost every tool a shop could have except a CNC.