- Joined
- Dec 27, 2006
- Messages
- 41
- Likes
- 0
My 3hp, 2436 has developed a noise and vibration in the motor. It is worse when the speed dial is at the 1,000 rpm position (if the belt is on the middle pulley). The noise is the same with the belt in place or with the belt off of the motor. The noise and vibration starts at about 600 RPM disappears when the speed reaches 1300 RPM. The lathe is number 1924.
I would appreciate any advice, as Oneway is on their mid summer break.
Thanks,
Dale Bright
I would appreciate any advice, as Oneway is on their mid summer break.
Thanks,
Dale Bright